• User Manual •
SB3125
Basic Phone
SB3125 User Guide
PRODUCT OVERVIEW:
9
10
11
1
2
3
4
5
8
6
7
Description:
1. IN USE LED
2. MUTE key
3. P-T key
4. PAUSE key
5. FLASH key
6. REDIAL key
7. 0-9/#/* key
8. Handset Cord jack
9. RINGER HI/LO switch
10. PULSE/TONE switch
11. TEL LINE jack
1. SWITCH OPERATION:
RINGER switch
You can set the ringer HI/LO volume using the switch.
PULSE/TONE switch
You can set the PULSE/TONE dial mode using the switch.
2
SB3125 User Guide
2. FUNCTION KEY OPERATION:
FLASH key (600ms)
In the on-hook mode, press this key to auto-hang up for 600ms, after that you can press
REDIAL key or dial out another number.
MUTE key
While you are on the line, if you do not want the remote party to hear you, just press and
hold the MUTE key.
REDIAL key
In the handset off-hook mode, press this key to redial the last dialed number.
PAUSE key
In the handset off-hook mode, press the PABX external line key, e.g. “9” follow by this key to
include a 3 seconds pause before dialing subsequent numbers.
P-T key
After switching to Pulse mode, you may press this key to change the dial mode to Tone.
3. ADDITIONAL NOTES:
IN USE LED
While handset is off hook, the LED will turn on.
TROUBLESHOOTING GUIDE:
(Q) I do not hear any dial tone from the handset.
(A) Ensure the handset cord is connected correctly to the handset cord jack at the base.
Ensure you have plug in the telephone cable from the telephone to the wall socket correctly.
If the problem persists, please check with your local dealer.
DECLARATION OF CONFORMITY:
The telephone complies with the essential protective requirements and objectives of:
•
•
•
•
EC R& TTE Directive 1999/5/EC
EC Low Voltage Directive 73/23/EEC
EC EMC Directive 89/336/EEC
And conforms to the following relevant harmonized standards:
•
•
EMC: EN55022, EN55024
Safety: EN 60950
Created on 28th October 2005. SB3125 Basic Phone.
Please visit us at www.shirocorp.com.
3
|