COMMERCIAL
SANDBLASTER
COMMERCIAL ELECTRIC WATER HEATERS
Designed for use as a recovery heater having its own storage tank. Note: Not recommended
for sanitizing water application.
MODELS
CSB 52, 82, 120
SURFACE MOUNT THERMOSTATS
FEATURES
Meets or exceeds the requirements of ASHRAE 90.1b-1992 and ASHRAE/IESNA 90.1-2004.
GOLD ELEMENTS - CSB models ship with the gold plated elements (see element
availability chart on back). Patented gold elements provide long life and superior scaling
resistance. Low watt density means lower surface temperature to minimize scale buildup
and more surface to heat water. Gold elements carry a one-year warranty against failure
due to lime scale build-up.
GLASS-LINED TANK - Three sizes: 50, 80 and 119 gallon capacity. Tank interior is
coated with glass specially developed for water heater use. Tanks rated at 150 psi (1034
kPa) working pressure (ASME 150 psi). Foam insulation reduces costly heat loss, and is
vermin proof.
FUSING - Protects all elements, thermostats, and internal wiring circuits against excess
current flow. Meets National Electrical Code requirements that non-ASME tanks must
have internal fusing when current draw exceeds 48 amps.
STANDARD VOLTAGES - 208, 240 and 480V single-phase and three-phase delta.
Convertible from three-phase to single-phase (in field) and vice versa. 277V single-phase
also available.
TERMINAL BLOCK - Factory installed. Just bring the service to the heater and connect to block.
CONTROLS - One temperature control (adjustable through a range of 120° to 180°F)
and manual reset high temperature cut-off per element. Thermostat step control may
be achieved by varying settings on individual temperature controls. Located behind
hinged control compartment door for quick, easy access.
OTHER STANDARD FEATURES -
Ŷ
Ŷ
Ŷ
Surface mounted thermostats
Simplified circuitry, color coded for ease of service
Ŷ
Two anode rods for maximum corrosion protection
with baked enamel finish
CSA / ASME temperature and pressure relief valve
Cabinet has bonderized undercoat
Brass drain valve
Single panel control box. THREE
Ŷ
Ŷ
Ŷ
Bottom inlet and top outlet openings
Ŷ
Ŷ
YEAR LIMITED TANK WARRANTY - For complete warranty information, consult written
warranty or contact State Water Heaters.
(OPTIONAL)
OPTIONS -
Ŷ
UL and cUL listed conversion kits to adjust voltage and kW requirements in the field
Ŷ
Ŷ
before and after installation ASME 150 psi tank construction International voltages -
220, 380, 400, 415, 575, and 600 volts, three phase available with Y connected elements
Ŷ
MANIFOLD KITS - for multiple tank installations. Two heaters -part # 9003429205,
three heaters- part # 9003430205 and four heaters- part # 9003431205
For more information on this product contact:
State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015
800.365.0024 Toll-free USA
SOLID.STATE.
SCESS00508
September 2010R
|